AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Rafter raised tie roof3/17/2024 We have asked S&K to design the full set of profiles (to accommodate our stairs and larger roof lights) and provide us the quote. 1 Location: Cornwall Posted OctoI recently moved into a house that has a roof with raised tie trusses and no internal supporting walls. The latter is 2.7m above finished floor level, so the north wing should be around 4.1m wide and 3.6m high. The raised-tie truss has the top collar (the ceiling level) almost 3m wide and 900mm above the wallplate. On a single-storey building it may be possible to place a temporary. The temporary diagonal brace placed on the top of the top chord should be at least 22 mm x 97 mm in section and well nailed to both plate and the trussed rafters as far up the rafter as practical. On the plus side, the design allows the attic room to be 4m wide, 2.2m high and with the ceiling slope starting 1.4m above floor level, much better than I had expected. Temporary bracing of these larger heavier trussed rafter components is vital. At the edges, the insulation can get squashed down pretty thin. However, manoeuvring long, heavy steels into place at high level can be enormously difficult, necessitating the use. Because they can span wide rooms, there is clear space for a thick blanket of insulation. Most loft conversions employ at least one pair of steel beams to support the new floor structure and the roof slopes at purlin level, and sometimes also at ridge level, e.g. Each truss will weigh just short of 100kg, handling them will be a beast. Manufactured roof trusses are a strong and efficient way to get a frame up fast. Where the wallhead goes outside the 195mm, we will either trim the blockwork back or can notch the rafters. The attic truss has a 190mm bearing width either side of the upright timbers, this should give us enough space for a wallplate to bear fully on the wallhead. Make sure to toenail on both sides of the truss on each end. Stevenson & Kelly have designed the basic attic truss profile for the east wing and the raised-tie truss profile for the north wing, to the most accurate dimensions I have. As with rafter installation, use an 8d nail, making sure that about 2/3 of the nail length ends up in the wall plate.
0 Comments
Read More
Leave a Reply. |